Servo Pusher 2158

The 3-axis Servo Pusher Type 2158 is part of the Heye Modular Servo Technology (HMST). It is used at IS-Machines with up to 24 sections.

Heye Pusher 2158
  • Heye Pusher 2158
  • Pusher Type 2158 in DG operation
  • Pusher 2158 in Quad Gob operation
  • Pusher 2158 in Quad Gob operation
  • Pusher 2158 in quad gob operation
  • Quad Gob Operation


  • Long service intervals, minimum wear, long lifetime
  • Simple operation of the pusher by setting the parameters via dialogue:
    Motion and speed profiles can be adapted to the article geometry and transport speed even during operation.
  • Compressed air to influence the article transport is not obligatory. If, nevertheless, compressed air should be needed due to production speed and weight of the article, “Integrated Pocket Air” is used. The dead plate is equipped with an air distributor to cover this option.
  • Most of the movable parts are located below the machine conveyor level inside the pusher housing, protecting them from enviromental influences such as heat and dirt.
  • Quick and simple exchange of the entire finger support including fingers
  • Pusher fingers made of carbon composite material (stainless steel on request)
  • In the case of a collision and resulting position loss the pusher returns to its home position to avoid affecting the bottle transport of neighbouring sections. After a blockage the pusher restarts automatically.
  • Switching output available to switch the gob off or to stop the section if the pusher completely fails.
  • Coupling with any IS E-Timing possible
  • Available for SG, DG, TG and QG applications

Published Articles

"Ware Handling for best results" - Glass Machinery, Plants & Accessories

"Precision leads to higher yield" - Glass International

Contact & Support

In case of questions or enquiries please contact us!

+49 5724 26-0

Contact via E-Mail

All lines busy?
Please use our callback service!